DSSN#T&R Maxim Integrated | DSSN#T&RCT-ND DigiKey Electronics Digi-Key Part Number, DSSN#T&RCT-ND Datasheets, DS Maxim Integrated DSSN#T&R: available from 12 distributors. Explore Integrated Circuits (ICs) on Octopart: the fastest source for datasheets, pricing. DS Extremely Accurate I²C RTC With Integrated Crystal And SRAM The DS is a low-cost temperature-compensated crystal oscillator (TCXO) with a.

Author: Taran Teshura
Country: Madagascar
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 12 July 2006
Pages: 451
PDF File Size: 1.36 Mb
ePub File Size: 12.35 Mb
ISBN: 451-7-90493-815-5
Downloads: 95176
Price: Free* [*Free Regsitration Required]
Uploader: Vumuro

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

Best Answer CW225 December – Two Wire Interface in Atmel lingo and when those pins are switched to I2C mode, they are configured as open-drain datasheet, p. Also, it is not really suitable for the microcontroller to have specific pull-up resistor value, because it depends on bus parameters, such ds32232sn speed, capacitance etc.

Posted 23 December – I have been successful with I2C in the past, and I believe that the “writes” I’m doing to the module work since my WriteTransactions return a nonzero value. I have tried reading by explicitly creating Transactions and also by using the MultiI2C library in the Netduino Toolbox.

  FULLA HORAK PDF

I2C Read Problem with DS RTC – Netduino Plus 2 (and Netduino Plus 1) – Netduino Forums

My test code is as follows — it attempts to read from the temperature register which should be nonzero. I have also tried writing a byte to the SRAM and reading the same address to no avail: Posted 24 December – Once again, I retreated to the Arduino vs3232sn managed to get the I2C going with this chip.

I’m not sure what the difference is between the following Rs3232sn code and the code posted above — could anyone enlighten me why Arduino is working and Netduino not-so-much? Posted 25 December – Thank you so much for responding.

I added pull-ups and sure enough, I’m getting my treasured values I feel like a fool, but at least it’s working now. Why does Netduino need pullups while the Arduino does not? Community Forum Software by IP.

DS3232 Extremely Accurate I²C RTC With Integrated Crystal And SRAM

Javascript Disabled Detected You currently have javascript disabled. The Netduino forums have been replaced by new forums at community.

  KONVENTA EVROPIANE E TE DREJTAVE TE NJERIUT PDF

This site has been preserved for archival purposes only and the ability to make new datasjeet or posts has been turned off. Go to the full post.

Please log in to reply. Any thoughts on why I might be experiencing this? The datasheet for this chip is located here: Does the Netduino follow a different protocol for sending a write and then a read transaction? Will it resend a start bit? If you want a treat and don’t mind the treatment Sorry for my english! Back to Netduino Plus 2 and Netduino Plus 1. Sign In Need an account?

I2C Read Problem with DS3232 RTC

I’ve forgotten my password. Remember me This is not recommended for shared computers. Sign in anonymously Don’t add me to the active users list. Username Forum Password I’ve forgotten my password Remember me This is not recommended for shared computers Sign in anonymously Don’t add me to the active users list Privacy Policy.